MIL-DTL-25895A
4.3.1.1 Mechanical. A visual inspection of the test set shall be made to verify that the materials, design and
construction, necessary mechanical measurements, marking, and workmanship comply with the requirements of this
specification. Each antenna shall be subjected to the immersion test of 4.2.5.
4.3.1.2 Electrical performance tests. Each antenna shall be subjected to the VSWR test of 4.2.7.1.
4.3.2 Sampling tests. Test samples shall be selected at random in accordance with the following:
Quantity of items to be tested
Quantity of items on order
1 to 25
1
26 to 50
2
51 to 75
3
76 to 125
4
126 to 200
5
201 to 300
6
Over 300
One for each additional 100 on order
4.3.2.1 Sampling test procedure. Each test item (see 4.3.2) shall be subjected to the preproduction tests specified
herein.
5. PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as specified in the contract or order
(see 6.2). When actual packaging of materiel is to be performed by DoD or in-house contractor personnel, these
personnel need to contact the responsible packaging activity to ascertain packaging requirements. Packaging
requirements are maintained by the Inventory Control Point's packaging activities within the Military Service or
Defense Agency, or within the Military Department's or Defense Agency's automated packaging files, CD-ROM
products, or by contacting the responsible packaging activity.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not mandatory.)
6.1 Intended use. The AT-505/AP is intended for use with airborne receiving and transmitting equipment in the
frequency range from 400 to 480 MHz. It is intended to be flush mounted with the skin of the aircraft in a pressurized
compartment.
6.2 Acquisition requirements. Acquisition documents should specify the following:
a. Title, number, and date of this specification.
b. Preproduction test samples. It is expected that the contract or purchase order will specify that a minimum of
three antennas will be required for preproduction samples and that these preproduction samples will be subjected to
the preproduction tests to determine compliance with the requirements of this specification. These antennas should
be considered as an additional quantity since it may not be economical to repair and deliver these antennas as
production items. The invitation for bids and the contract should specify the point of inspection for these tests.
c. Shipment marking. Shipment marking nomenclature is Antenna AT-505/AP.
6.3 Rejection materials. The right is reserved to reject any materials which have not been subjected to the
required tests and found satisfactory.
5
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business