MIL-DTL-287J
COMMERCIAL ITEM DESCRIPTIONS
A-A-59588
-
Rubber, Silicone.
DEPARTMENT OF DEFENSE SPECIFICATIONS
MIL-DTL-85
-
Waveguides, Rigid, Rectangular, General Specification for.
MIL-DTL-3922
-
Flanges Waveguide, General Purpose, General Specification for.
MIL-DTL-5541
-
Chemical Conversion Coatings on Aluminum and Aluminum Alloys.
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-202
-
Electronic and Electrical Component Parts.
(Copies of these documents are available online at https://assist.daps.dla.mil/quicksearch or from the
Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
2.3 Non-Government publications. The following documents form a part of this document to the extent specified
herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or contract.
ASTM INTERNATIONAL AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM)
ASTM-B700
-
Electrodeposited Coatings of Silver for Engineering Use.
(ASTM publications are available from ASTM International, 100 Barr Harbor Drive, West Conshohocken, PA
19428-2959 or online from https://astm.org.)
NATIONAL CONFERENCE OF STANDARDS LABORATORIES (NCSL)
NCSL-Z540.3
-
Calibration of Measuring and Test Equipment, Requirements for.
(Copies are available online at https://www.ncsl.org or at National Conference of Standards Laboratories, 2995
Wilderness Place, Suite 107, Boulder, CO 80301-5404.)
SAE INTERNATIONAL (SAE) AEROSPACE MATERIALS SPECIFICATIONS (AMS)
SAE-AMS-S-8802
-
Sealing Compound, Temperature Resistant, Integral Fuel Tanks and
Fuel Cell Cavities, High Adhesion.
SAE-AMS-R-25988
-
Rubber, Fluorosilicone Elastomer, Oil-and-Fuel-Resistant, Sheets,
Strips, Molded Parts, and Extruded Shapes.
(Copies are available from SAE International, 400 Commonwealth Drive, Warrendale, PA 15096-0001, or online
from https://www.sae.org.)
2.4 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict between the
text of this document and the references cited herein (except for related specification sheets), the text of this
document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations
unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Specification sheets. The individual item requirements shall be as specified herein and in accordance with
the applicable specification sheets. In the event of any conflict between the requirements of this specification and of
the specification sheets, the latter shall govern.
3.2 First article. Assemblies furnished under this specification shall be products that have been tested and
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business