MIL-DTL-18793B
DEPARTMENT OF DEFENSE STANDARDS
-
Environmental Engineering Considerations and Laboratory Tests.
(Copies of the above specifications, standards, and handbooks are available at https://assist.daps.dla.mil/ or from
Standardization Document Order Desk, Building 4D, 700 Robbins Avenue, Philadelphia, PA 19111-5094.)
2.2.2 Other Government documents, drawings, and publications. The following other Government documents,
drawings, and publications form a part of this document to the extent specified herein. Unless otherwise specified,
the issues of these documents are those cited in the solicitation or contract.
NAVAL AIR SYSTEMS COMMAND
E-1529
-
Antenna AS-333/AP, Assembly and Detail Drawing.
E-1530
-
Antenna AS-333/AP, Case.
49A1H2
-
Antenna AS-333/AP, Component Details.
(Copies of these documents are available from Commander, Naval Air Systems Command, Code 4.1.4, Highway
2.3 Non-Government publications. The following documents form a part of this document to the extent specified
herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or contract.
IPC (Association Connecting Electronics Industries)
-
Soldering Fluxes, Requirements for.
-
Soldering Pastes, Requirements for.
-
Electronic Grade Solder Alloys and Fluxed and Non-Fluxed Solid Solders for Electronic
Soldering Applications, Requirements for.
(Applications for copies should be addressed to IPC - Association Connecting Electronics Industries, 2215 Sanders
Road, Northbrook IL 60062-6135 or at https://www.ipc.org.)
2.4 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict between the
text of this document and the references cited herein, the text of this document takes precedence. Nothing in this
document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Parts and materials. In the selection of parts and materials, fulfillment of major design objectives shall be the
prime consideration. In so doing, the following factors shall govern:
Parts and materials approved to specifications listed in MIL-E-5400 shall be given first consideration.
a.
b.
If the contractors can demonstrate that the use of standard AN or JAN parts or materials will not fulfill the
design objectives because of size, weight, performance, or other reasons, material and parts shall be used
which most nearly meet or exceed the performance requirements of the respective standard specification,
provided that no deterioration of size, weight, performance, or reliability will result in the use of such
substitutions.
c.
In all cases, the meeting of general material requirements such as non-inflammability, fungus resistance, or
non-toxicity and the meeting of environmental conditions as required by MIL-E-5400 or MIL-STD-810 must
be of prime consideration.
d.
Pure tin requirements shall be as specified in 3.2.12.
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business