MS25050B
NOTES:
1. Dimensions in inches, unless otherwise specified, tolerances: one place decimal ±.1, two place decimals ±.02.
2. This specification sheet takes precedence over documents referenced herein.
3. Referenced Government documents of the issue listed in that issue of the Department of Defense Index of
Specifications and Standards (DODISS) specified in the solicitation form a part of this specification to the extent specified herein.
4. Material: Body, dielectric suitable for the purpose.
5. Threads shall conform to MIL-S-7742.
6. Maximum weight: .50 pounds.
FIGURE 1. Dimensions and configuration - Continued.
MS PIN |
A |
|
Max |
Min |
|
MS25050-1 |
5.5 |
4.1 |
Procurement specification: MIL-DTL-7965.
Referenced documents. In addition to MIL-DTL-7965, this document references the following: MIL-S-7742
MS25051
MS25056
The margins of this specification are marked with vertical lines to indicate modifications generated by this amendment. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations.
Custodians: Preparing activity: Navy - AS DLA- CC
Air Force - 11
DLA - CC (Project 5985-1330)
Review activity: Air Force - 99
NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https://assist.daps.dla.mil.
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business