MIL-DTL-55288E
2.3 Non-Government publications. The following documents form a part of this document to the extent
specified herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or
contract.
ASTM INTERNATIONAL
ASTM-D3935
-
Material Polycarbonate (PC) Unfilled and Reinforced.
(Copies are available online at https://www.astm.org or may be obtained from ASTM International, 100 Barr Harbor
Drive, West Conshohocken, PA 19428-2959)
HEWLETT PACKARD
Hewlett Packard Journal Volume 15, No. 6.
(Copies are available online at https://www.hp.com or may be obtained from Hewlett-Packard Corporation, 1501
Page Mill Road, Palo Alto, CA 94304.)
NATIONAL CONFERENCE OF STANDARDS LABORATORIES (NCSL)
NCSL Z540.3
-
Calibration of Measuring and Test Equipment, Requirements for.
(Application for copies of NCSL publications should be addressed to National Conference of Standards
Laboratories, 2995 Wilderness Place Suite 107, Boulder, CO 80301-5404 or online at https://www.ncsli.org.)
2.4 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict between the
text of this document and the references cited herein, the text of this document takes precedence. Nothing in this
document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Construction AS-1729/VRC. The antenna shall be constructed in accordance with the applicable drawings
indicated below:
Unit
NSN
Drawing
Data List
Antenna, AS-1729/VRC Assembly
5985009859024
CECOM DWG SM-D-542010
Antenna Element AT-1095/VRC
5820008562728
CECOM DWG SM-D-415406
CECOM DWG SC-DL-415405
Antenna Element AS-1730/VRC
5985009859022
CECOM DWG SM-C-542002
CECOM DWG SC-DL-542000
Matching Unit-Base, MX-6707/VRC
5820009061115
CECOM DWG SM-D-542021
CECOM DWG SC-DL-542020
Antenna Tie-Down Assembly
4020009086416
CECOM DWG SC-C-208747
3.2 First article. The contractor shall furnish four (4) first article samples of Antenna AS-1729/VRC for approval if
required in contract.
3.3 Parts, materials, and process. The contractor shall use all items specified in the Government furnished
Technical Data Package (TDP) or in the Government model. The TDP shall serve as the Program Parts Selection
List (PPSL).
3.4 Castings. Zinc-alloy, aluminum-alloy, and magnesium-alloy die castings shall be used only when approved by
the Contracting Officer for the particular application.
3.4.1 Quality of die casting (see 4.4). Quality of die castings shall be as follows:
a.
Surface condition shall be clean, dry, and free from chips.
b.
Cast surface finish shall be of a painting grade which allows some streaks and chill marks which can be
covered and hidden by paint.
c.
Flash must be removed by grinding or filing.
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business