MIL-HDBK-660 Fabrication Of Rigid Waveguide Assemblies Sweep Bends And TwistsThis handbook is intended for the electronic installations technician to be used as a guide for fabricating rectangular waveguide bends and twists used in the microwave region of the electronic spectrum.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47

MIL-HDBK-660B

2.  APPLICABLE DOCUMENTS

2.1  General.  The documents below are not necessarily all of the documents referenced herein, but are those needed to understand the information provided by this handbook.

2.2  Government documents.

2.2.1  Specifications, standards, and handbooks.  The following specifications, standards, and handbooks form a part of this document to the extent specified herein.

FEDERAL SPECIFICATIONS

O-F-499                     -             Flux, Brazing (Silver Brazing Filler Metal, Low Melting Point). QQ-B-654                  -             Brazing, Alloys, Silver.

DEPARTMENT OF DEFENSE SPECIFICATIONS

MIL-DTL-3970    -             Waveguide Assemblies, Rigid, General Specification for.

(Copies of these documents are available online at https://assist.dla.mil/quicksearch/ or from the Standardization

Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA  19111-5094.)

2.2.2  Other Government documents, drawings, and publications.  The following other Government documents, drawings, and publications form a part of this document to the extent specified herein.

2.3  Non-Government publications.  The following document(s) form a part of this document to the extent specified herein.

AMERICAN SOCIETY OF MECHANICAL ENGINEERS (ASME)

ASME B46.1              -             Surface Texture (Surface Roughness, Waviness, and Lay).

(Application for copies should be addressed to:  American Society of Mechanical Engineers (ASME), 3 Park

Avenue, M/S 10D, New York, NY 10016-5990.)

AMERICAN WELDING SOCIETY (AWS)

AWS A5.8                  -             Filler Metals for Brazing and Braze Welding.

(Application for copies should be addressed to:  American Welding Society (AWS), 550 N. W. LeJeune Road, Miami FL 33126.)

2.4  Order of precedence.  In the event of a conflict between the text of this document and the references cited herein, the text of this document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.

5