MIL-PRF-49204B(CR)
TABLE VI.
Group C inspection.
TITLE
REQUIREMENT
INSPECTION
SUB GROUP
PARAGRAPH
PARAGRAPH
II
4.14.7
3.8.9
Immersion
II
4.14.1
3.8.1.1
High Temperature
II
4.14.2
3.8.1.2
Low Temperature
III
4.14.3
3.8.2
Humidity
IV
4.14.4
3.6.5
Antenna Gain
IV
4.14.5
3.8.7
Drop
IV
4.14.6
3.8.8
Wind Load
IV
4.11.2
3.8.4
Salt Fog
IV
4.11.3
3.8.5
Dust
IV
4.11.5
3.8.6
Bounce Loose Cargo
IV
4.11.1
3.8.3
Fungus
4.6.1 Sampling for inspection of equipment. Units selected for each
Group C inspection shall be selected without regard to their quality in
accordance with the following:
a. Subgroup II. For this subgroup, two units for the first 50
production units shall be selected for this Group C inspection. For
subsequent Group C inspections, two units from each successive 500, or two
every two months, if less than 500 are produced during a two month period.
b. Subgroup III. For this subgroup, two units from the first 50
production units shall be selected for the first Group C inspection. For
subsequent Group C inspections, two units shall be selected from each
successive 600, or two every three months, if less than 600 are produced
during this three month period.
c. Subgroup IV. For this subgroup, two units from the first 50
production units only shall be selected. Subsequently, two units shall be
tested every six (6) months until completion of production.
4.6.2 Procedure in the event of failure during Group C inspection.
The
procedure shall be as specified in the contract or purchase order.
4.6.3 Reinspection of conforming Group C sample units. Unless
otherwise specified, sample units which have been subjected and passed Group C
inspection may be accepted on the contract or order provided all damage is
repaired and the sample units are resubjected to and pass Groups A and B
inspections.
4.7 Supplementary tests. Supplementary tests are defined as those
tests herein which are only conducted as a pretest and/or post test to a first
article or Group C test.
4.8 Standard test conditions. Unless otherwise specified, the
following standard test conditions shall prevail during testing.
Condition
Value/Tolerance
Temperature
Prevailing Ambient
Altitude
Ground Level
10
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business