MIL-DTL-24044C
TABLE I. Material Inspection.
Material
Requirement
Applicable specification or
paragraph
publication
Copper-base alloys:
---
Bar stock:
---
Leaded red brass
Leaded brass
Naval brass
Castings (leaded tin bronze)
Forging:
Leaded brass
Naval brass
3.2.1.3
Aluminum-base alloys:
Bar stock and forging
Sand casting
Die casting
3.2.2.3
Permanent mold casting
Silicon rubber
Phosphor bronze
Corrosion-resisting (stainless) steel
Polytetrafluoroethylene
4.4 Inspection conditions. Unless otherwise specified herein, all inspection shall be made at room ambient
temperature, relative humidity, and pressure.
4.5. Conformance inspection.
4.5.1 Inspection of product for delivery. Inspection of product for delivery shall consist of groups A, B, and C.
4.5.1.1 Inspection lot. An inspection lot, as far as practicable, shall consist of all the flanges of the same PIN,
produced under essentially the same conditions, and offered for delivery at one time.
4.5.1.2 Rejected lots. If an inspection lot is rejected, the supplier may withdraw the lot, rework it to correct the
defects, or screen out the defective units, as applicable, and reinspect. Such lots shall be separate from new lots and
shall be clearly identified as reinspected lots.
4.5.1.3 Group A inspection. Group A inspection shall consist of the examinations or tests specified in table II and
shall be made on the same set of samples.
TABLE II. Group A Inspection.
Examination or test
Requirement paragraph
Method paragraph
Visual and mechanical
Interface and construction
---
Workmanship
---
Marking
---
Surface roughness
5
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business