MIL-DTL-24211C
2.3 Non-Government publications. The following documents form a part of this document to the extent specified
herein. Unless otherwise specified, the issues of these documents are cited in the solicitation or contract (see 6.2).
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
-
Alloy and Temper Designation Systems for Aluminum.
(Applications for copies of ANSI publications should be addressed to ANSI, 11 West 42nd Street, New York, NY
10036 or by e-mail at https://web.ansi.org.)
ASTM INTERNATIONAL (ASTM)
Aluminum-Alloy Sand Castings.
Aluminum-Alloy Die Castings.
Aluminum-Alloy Permanent Mold Castings.
-
Aluminum and Aluminum-Alloy Sheet and Plate.
-
Aluminum and Aluminum-Alloy Bar, Rod and Wire.
-
Aluminum and Aluminum-Alloy Extruded Bars, Rods, Wire, Profiles and Tubes.
(ASTM publications are available from ASTM International, 100 Barr Harbor Drive, Conshohocken, PA 19428-
2959 or from https://astm.org).
NATIONAL CONFERENCE OF STANDARDS LABORATORIES (NCSL)
-
Calibration Laboratories and Measuring and Test Equipment .
(Copies of the above document are available at National Conference of Standards Laboratories (NCSL), 2995
Wilderness Place Suite 107, Boulder, CO 80301-5404, United States, or at https://www.ncsli.org.)
SAE INTERNATIONAL (SAE) AEROSPACE MATERIALS SPECIFICATIONS (AMS)
Plating, Cadmium (Electrodeposited).
(Society of Automotive Engineering documents are available through SAE INTERNATIONAL, 400
Commonwealth Drive, Warrendale, PA 15096-0001, https://www.sae.org.)
(Non-Government standards and other publications are normally available from the organizations which prepare
or distribute the documents. These documents also may be available in or through libraries or other informational
services.)
2.4 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict between the
text of this document and the references cited herein (except for related specification sheets), the text of this
document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless
a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Specification sheets. The individual item requirements shall be as specified herein and in accordance with
the applicable specification sheet. In the event of any conflict between the requirements of this specification and the
specification sheet, the latter shall govern.
3.2 Materials. The material for each part shall be as specified herein and in table I. When a definite material is
not specified, a material shall be used which will enable the gaskets and the subassemblies to meet the
performance requirements of this specification (see 6.2.e). Acceptance or approval of any constituent material shall
not be construed as a guaranty of acceptance of the finished product (see 4.6.1).
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business