MIL-DTL-39030F
ASTM-D4894
-
Standard Specification For, Polytetrafluoroethylene (PTFE) Grandular Molding and
RAM Extrusion Materials,
ASTM-D4895
-
Polytetrafluoroehylene (PTFE) Resins Produced From Dispersion.
(Copies of these documents are available from https://www.astm.org or ASTM International, P.O. Box
C700, 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959.)
AMERICAN SOCIETY OF AUTOMOTIVE ENGINEERS (SAE)
SAE-AMS2700
- Steels, Passivation of Corrosion Resistant.
SAE-AMS-QQ-N-290
- Nickel Plating (Electrodeposited).
SAE-AMS2404
- Coatings, Electroless Nickel, Requirements For.
(Copies of these documents are available online from https://www.sae.org or from the Society of
Automotive Engineers, 400 Commonwealth Drive, Warrandale. PA 15096-0001.)
2.4 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict
between the text of this document and the references cited herein (except for related specification
sheets), the text of this document takes precedence. Nothing in this document, however, supersedes
applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Specification sheets. The individual item requirements shall be as specified herein and in
accordance with the applicable specification sheets. In the event of any conflict between the
requirements of this specification and the specification sheet, the latter shall govern (see 6.2).
3.2 Qualification. Dummy loads furnished under this specification shall be products that are authorized
by the qualifying activity for listing on the applicable qualified products list before contract award (see 4.5
and 6.3).
3.2.1 QPL system. The manufacturer shall establish and maintain a QPL system for parts covered by
this specification. Requirements for this system are specified in MIL-STD-790. In addition, the
manufacturer shall establish a Statistical Process Control (SPC) system that meets the requirements of
3.2.2.
3.2.2 SPC system. As part of the overall, the manufacturer shall establish a SPC system that meets the
requirements of MIL-STD-790 QPL system.
3.3 Critical interface materials. Materials shall be as specified herein. If materials other than those
specified are used, the contractor shall certify to the qualifying activity that the substitute material enables
the dummy loads to meet the requirements of this specification. Acceptance or approval of any
constituent material shall not be construed as a guaranty of the acceptance of the product. When a
definite material is not specified, a material shall be used which will enable the dummy load to meet the
performance requirements of this specification.
3.3.1 Dissimilar metals. Dissimilar metals between which an electromotive couple may exist shall not
be placed in contact with each other. Reference is made to MIL-STD-889 for definition of dissimilar
metals.
3.3.2 Nonmagnetic materials. All parts shall be made from materials, which are classified, as
nonmagnetic. (less than 2 mµ).
4
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business