GRC. The OE-303 is also referenced herein as: The antenna system.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22

MIL-DTL-49295C

ELECTRONICS COMMAND DRAWINGS

DL-A3010408

Antenna Group OE-303/GRC.

(Copies of specifications, standards, handbooks, and drawings required by contractors in connection with specific

acquisition functions should be obtained from the acquiring activity or as directed by the contracting officer.)

2.3 Non-Government publications. The following documents form a part of this document to the extent specified

herein. Unless otherwise specified, issues of these documents are those cited in the solicitation or contract (see 6.2).

TELECOMMUNICATION INDUSTRY ASSOCIATION (TIA)

Minimum Standards for Communications Antennas, Base Station Antennas.

(Applications for copies should be addressed to Telecommunication Industry Alliance 2500 Wilson Boulevard,

Arlington, Virginia, 22201 or online at https://www.tiaonline.org.)

2.4 Order of precedence. In the event of a conflict between the text of this document and the references cited

herein the text of this document takes precedence. Nothing in this document, however, supersedes applicable laws

and regulations unless a specific exemption has been obtained.

3. REQUIREMENTS

3.1 Classification of requirements. The requirements for this item are classified herein as follows:

Requirement

Paragraph

Construction

Structural Integrity

Electrical

Service conditions

3.1.1 First article. When specified, a sample shall be subjected to first article inspection (see 4.2).

3.2 Construction.

3.2.1 General. All piece-parts, sub-assemblies, and the final assembly of Antenna Group OE-303( )/GRC shall be

constructed in accordance with the drawings listed on Data List DL-A3010408.

3.2.2 Interchangeability. Like units, sub-assemblies, assemblies, and replaceable parts shall be physically and

functionally interchangeable without modification of the items or of the antenna system. Individual items shall not be

handpicked for fit or performance. Reliance shall not be placed on any dimension, rating, or characteristic, not

specified on the drawings. For like units, assemblies and replaceable parts guidance see 4.12, table III.

3.2.3 Finish. The antenna system shall be finished in accordance with paint finish requirements of MIL-DTL-14072

for Type I (exposed) equipment surfaces (see 4.11, 4.3).

3.2.4 Marking. Marking shall be in accordance with MIL-STD-13231. Classification of defects in MIL-STD-13231

is applicable (see 4.13, 4.3).

3.2.5 Weight. For first article samples, weight of the complete antenna, with all parts, transmission line and the

technical manual stowed in the bag, shall not exceed 42 pounds. For all other inspection samples weight shall not

exceed 42 pounds or shall be within + .5 lb of the average weight of first article samples, whichever is least. Weight

of each matching transformer assembly shall not exceed 18 ounces (see table III).