MIL-DTL-49295C
4. VERIFICATION
4.1 Classification of inspection. Inspection shall be classified as follows:
a. First article inspection (does not include preparation for delivery) (see 4.2).
b. Inspection covered by subsidiary documents (see 4.3).
c. Conformance inspection (see 4.4).
(1) Conformance inspection of equipment (see 4.4).
4.1.1 Inspection conditions. Unless otherwise specified, all inspections shall be performed in accordance with the
4.2 First article inspection. Unless otherwise specified in the contract or purchase order, the first article inspection
shall be performed by the contractor. The first article inspection shall consist of the inspection specified in subsidiary
documents covering the items listed in 4.3, the inspection specified for group A, group B, and group C. The
inspection shall be performed in the following order: 4.3, group A and group B for all units, and group C as specified
in table I. After completion of group C test, conforming units shall be reinspected and shall pass all group A
inspection. The contractor shall be required to repair and retest at his own expense any units that have failed tests
required herein until those units have satisfactorily passed specified requirements.
4.2.1 First article units. The contractor shall furnish five (5) first article units of the complete OE-303/GRC that
shall reflect material and conditions that will be used in production.
4.3 Inspection covered by subsidiary documents. The following shall be inspected under the applicable subsidiary
documents as part of the inspection of equipment before preparation for delivery.
Item
Paragraph
Workmanship
Finish
Marking
Parts, materials and processes
used in electronic equipment
4.4 Conformance inspection of equipment. The contractor shall perform the inspection specified in 4.3 through
4.13. This does not relieve the contractor of his responsibility for performing any additional inspection that is
necessary to control the quality of the product and to assure compliance with all specification requirements. The
Government will review and evaluate the contractor's inspection procedures and examine the contractor's inspection
records. In addition, the Government, at its discretion, may perform all or any part of the specified inspection, to
verify the contractor's compliance with specified requirements. Test equipment for Government verification
inspection, shall be made available by the contractor. Further, all facilities and services necessary for the placement,
operation and maintenance, of this test equipment shall be provided by the contractor.
4.4.1 Group A inspection. Each unit on contract or purchase order shall be inspected for conformance to
inspections specified in table II. Discrete lots shall be formed from units that pass this inspection. Each lot shall be
subjected to sampling inspection.
4.4.1.1 Order of inspection within group A. Group A inspection shall be performed in an order satisfactory to the
Government.
4.4.1.2 Procedure in the event of failure during group A inspection. In the event of failure to pass any group A
inspection item, the unit shall be corrected as necessary and then resubmitted to group A inspection.
4.4.2 Group B inspection. This inspection (including sampling) shall conform to table III. Group B inspection shall
normally be performed on inspection lots that have passed group A inspection and on samples selected from units
that have been subjected to and that have met group A inspection.
6
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business